Looking for:
Eemax water heater manual. EemaX EMT4 Manuals |
Help – Eemax Tankless.Eemax EMT4 Manuals | ManualsLib
This water heater must be grounded. Connect only to properly grounded outlet. Install or locate this water heater only in accordance with the provided installation instructions. Water Pressure psi Weight empty lbs. EMT models are designed to supply hot water for all hand wash and kitchen sinks in a residential, commercial or industrial environment. EMT models can replace traditional central hot подробнее на этой странице heaters thereby conserving water and reducing energy waste.
EMT models can also be plumbed in series with the central water heater and act as a booster. The pressure vessel water eemax water heater manual is welded, glass lined steel and is equipped with an anode rod. The water heater is equipped with a thermostat and a high limit temperature switch. Failure to provide dielectric insulation may result in premature tank or nipple failure and may void your warranty.
Insure that the water heater is installed in a level position. Must NOT be smaller in diameter than the outlet diameter of the valve, or have any reducing couplings.
Must NOT be plugged or blocked. Must be eemax water heater manual of suitable material for hot water. Must not have autodesk maya minimum requirements than two elbows. Must terminate at an adequate drain. Must not have a shut off valve between relief valve and tank or relief valve and termination of discharge. Before connecting the power, fill the tank and system with water and check for leaks.
To be sure that all air is out of the water system, eemax water heater manual the hot water eemax water heater manual on your fixtures until constant water flows from them. Otherwise any air remaining in the tank will cause the water heater element to self destruct. If air remains in the tank, the element will be damaged when the electric cord is plugged in.
Adhere to eemax water heater manual pertinent State and local codes. You are now ready to use your water heater.
Run the hot water at a nearby sink and evaluate the hot water eemax water heater manual. The red indicator lamp remains illuminated while the water is being heated. Call a service person plumber or electrician for service assistance. Always unplug the power supply cord when the water is turned off or when servicing or draining the water heater. Before calling for service, first confirm that the water heater is properly filled and that VAC power has not been interrupted.
Heavy scale can even cause the element to burn out. The element can be descaled chemically or manually. Remove the heating element see above. To descale chemically, soak the eemax water heater manual element in white vinegar or other descaling solution and then rinse well with fresh water.
This shut down will occur when water temperatures exceed F. Power is automatically turned off to the heating element. The shut off device may activate as a result of a power outage or an electrical storm. NOTE: Do not attempt to reset eemax water heater manual high limit switch without first allowing the water heater to cool down the high temperature water inside the heater.
Make sure the power supply is on and working. If light does not come on, check that the reset button is pushed in; follow steps from previous section.
If the indicator light is illuminated, but water temperature does not get hot at the sink, test for a plumbing crossover as follows; shut off cold water supply to water heater and open hot water tap.
There should be no water flowing. Name of Part Qty. Exclusions of Coverage from this Limited Warranty 1. Manufacturer is not liable for any water damage or other damages arising, directly or indirectly, from any defect in the Eemax Mini Tank Water Heater component part s or from its use.
Manufacturer is not liable under this limited warranty or otherwise if: a. The water heater or any of its component parts have been subject to misuse, alteration, neglect or accident; or b. Eemax Inc. Electric Mini T ank W ater Heaters.
Comments
Post a Comment